ACSS for UPZ RC10 installation question

Various topics, technical questions, announcements, events, resorts, ...

Moderators: Arnaud, nils, fivat, rilliet

ACSS for UPZ RC10 installation question

Postby slayer » Tuesday 21 February 2017, 16:39

Hi all,

When I place the bottom piece against the slot on the boot, as per the picture, in this area, the boot surface not flat, but a curve. Do I need to sand it flat? It is not mentioned in the PDF, but the video shows this area sanded down a bit (i think, picture is not that sharp).

(sorry, the picture comes out upside down)
ACSS_q (Small).jpg
ACSS_q (Small).jpg (57.64 KiB) Viewed 1541 times


cheers,
Slayer
Swoard Dual 175, UPZ RC10 boots, F2 Race Titanium bindings.
slayer
Rank 4
Rank 4
 
Posts: 88
Joined: Friday 17 January 2014, 1:34

Re: ACSS for UPZ RC10 installation question

Postby Capykiller » Tuesday 21 February 2017, 17:15

Hi Slayer,
as you mentioned in your post I sandpaper the part a bit to make the bottom piece fit.

All the best from germany

https://youtu.be/4exQTkBn-kE
SWOARD EXtremecarver Pro 168H, SWOARD Bindung Redline, Xtasy Nirvana, UPZ RC 10
User avatar
Capykiller
Rank 5
Rank 5
 
Posts: 116
Joined: Sunday 21 October 2012, 1:04
Location: Essen

Re: ACSS for UPZ RC10 installation question

Postby slayer » Tuesday 21 February 2017, 17:55

Thanks Capykiller.

Is it critical how much to take off, or do I just make the ridge fit right-angles to the boot? Would you be able to show a closeup?

Sorry to be 'precious' - I haven't yet drilled holes in expensive boots! :-)

I better go to my storage to find my Dremel! One thing about living in Swiss rented accomodation compared to the UK - toolbox is a lot smaller!

EDIT - now I watched the video again, and turned on the (indecipherable) auto-translate captions, I can see you mention shaving off some plastic. Need to learn more German! :-)

cheers,
Slayer.
Swoard Dual 175, UPZ RC10 boots, F2 Race Titanium bindings.
slayer
Rank 4
Rank 4
 
Posts: 88
Joined: Friday 17 January 2014, 1:34

Re: ACSS for UPZ RC10 installation question

Postby Arnaud » Tuesday 21 February 2017, 18:18

Hi Colin
You cut a little bit the shape to get it flat
Swoard EC Pro 168H - 168H G1- Dual 168 - Donek Axis 172
User avatar
Arnaud
Administrator
Administrator
 
Posts: 3095
Joined: Friday 24 January 2003, 9:00
Location: Paris - IdF 95


Return to Miscellaneous

Who is online

Users browsing this forum: No registered users and 6 guests